Sets the volume of the overdriven signal.
Sets the amount of saturation in the overdriven signal.
Mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine control of the blend ratio.
Sets the amount of low frequency content to saturate by selecting between three different bass boost levels before the clipping stage.
Sets the amount of treble content to saturate: The "Boost" setting emphasizes the treble content extra clarity and presence. The "Flat" position leaves this register untouched while the "Cut" position will reduce the amount of high frequencies being saturated.
+-12dB @ 100Hz
+-12dB @ 1kHz
+-12dB @ 2.8kHz
+-12dB @ 5kHz
A balanced version of the ¼” output, useful for running into PA’s or studio mixing consoles.
12×10.7 cm (4.72×4.21 in)
The Microtubes B7K has a current draw of 30mA. Only use a regulated 9V DC adapter with a center-negative plug. Due to ecological reasons it does not accept batteries. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.
Microtubes B7K Limited Edition (Acid Toad) Artist
"Touring can be hard on your gear. Darkglass are solid! Built like tanks, and reliable. Not only that, but I can always dial in the tone I need in seconds, be it a slight boost, or the sound of the universe exploding. No matter what I need there's always an overdrive that sits perfectly in the mix. And man...that blue light! — Photo cortesy of: Kristell Gathoye"
Adam “Nolly” Getgood
"With the Microtubes, Darkglass have totally nailed the perfect balance of aggression and clarity. I can’t believe how much distortion you can dial in without compromising the note fundamental or sheer amount of low end. The 3 different modes are all distinct and cover a large range of sounds – whether live or in the studio, you’ll never need another bass overdrive pedal! "
In the interest of continuous improvement, specifications are subject to change without notice. If you have any questions, please don’t hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.